top of page

KRIX

MEGAPHONIX CENTRE IN-WALL

IN-WALL

Downloads

The Megaphonix In-Wall Centre is designed to be installed below televisions or non-acoustically transparent projector screens.

The Megaphonix In-Wall Centre is designed to be installed below televisions or non-acoustically transparent projector screens. Using high power handling and high sensitivity drivers, these speakers will deliver crystal clear dialogue and dynamic effects, for a real home cinema experience.

The 255mm bass driver has a 50mm voice coil and has been developed to offer low harmonic distortion, especially in the critical midband. The paper cone and surround of the bass driver have been developed to provide the smoothest possible response. The high frequency drive unit is a specially-damped, high power, 26mm doped fabric dome tweeter, and is coupled with Krix’s proprietary waveguide to provide consistently-maintained optimum dispersion of 90 degrees horizontal and 40 degrees vertical over the entire working bandwidth.

The combined high frequency response is exceptionally smooth and well controlled – a new benchmark in loudspeaker reproduction.

Finished with a powder coated steel front baffle for easy installation, the Megaphonix In-Wall Centre is the perfect answer for a concealed, horizontal installation while maintaining exceptional performance.

For the ultimate cinema experience at home, play it through Krix.

Specification

Frequency range

40Hz-20kHz in room response


Power handling

50-250 Watts RMS recommended amplifier power


Sensitivity

95dB for 2.83 volts at 1 metre


Impedance

8 Ohms


Configuration

2-way


Enclosure type

Bass reflex, front vented


Low frequency driver

Single 255mm (10”) paper cone driver. 50mm (2”) voice coil wound on high powered kapton former, with ventilated magnet assembly and copper shorting ring for low distortion


High frequency driver

26mm (1”) doped fabric dome with large roll surround. Ferro fluid cooled. Coupled to a Krix designed 90 x 40 short throw waveguide


Crossover point

1.8kHz


Input terminals

Nickel plated spring terminals featuring a 5mm hole to accept up to 10AWG cable


Cut-out dimensions

295mm high x 1045mm wide recommended


Dimensions

285mm high x 1035mm wide x 150mm deep cabinet367mm high x 1117mm wide x 2mm thick faceplate


Weight

23kg each

bottom of page